Pressure water valve,solenoid valve,air pneumatic cylinder-Cast Brass Valve ‎was replaced by moldi

Conversion of a control valve of the water with a slight bronze cast Assembly, while saving material costs.pressure water valve

Previously,solenoid valve the valve is cast bronze and had several costly mistakes to create complex flow paths.air pneumatic cylinder



The device is a dual-tank water valve control provides a continuous supply of soft water from a tank and a second container is regenerated. The control valve controls the flow of resin regeneration, rinsing and flushing of the water softener. Measure 5 x 3-3/4 x 5 inches, the service valve, and two tanks of water softener resin.



The design challenge was to meet regulatory requirements of structural performance and combat pollution of the water flow without.



A three-block body configuration is achieved by the three components of the hot plate welded together.



The advantages of the control valve includes a new weight reduction of 7 percent water, non-corrosive, and the same input and output are welded to the brass valve. Use of lead has also been eliminated.