Pressure water valve,ir pneumatic cylinder-Installation instructions of water valve

1. Automatic replenishment valve can be installed horizontally or vertically, but not reversed, that is not plastic knob on the top.pressure water valve

2. Watch automatic replenishment valve exit pressure gauge, adjust the top of air pneumatic cylinder the hexagonal brass nut until it reaches the required operating system pressure solenoid hydraulic valve

3. Proposed automatic replenishment valve static pressure is higher than the 0.3 kilograms, but less than the supply water pressure needed to set the value, otherwise there can not be normal replenishment.

4. Automatic replenishment valve automatically to set the injection pressure, injection time longer.

5. If you need to interrupt auto-pay, you can manually turn off the automatic replenishment valve on the valve.

6. If the automatic replenishment valve spool may replace or clean dirty cartridge.

Makeup valve repair method:

1. Turn off the automatic replenishment valve upstream of the valve;

2. Open the automatic replenishment valve valve;

3. Completely loosen the automatic replenishment valve adjusting screw;

4. Forceps to remove the automatic replenishment valve spool;

5. If the automatic replenishment valve spool may be dirty or broken valve replacement or cleaning;

6. All parts bottles and reset the supply water pressure.